OBD2 Cable Technical Resources
Pinout tables, adapter codes and software references for the OBD-II diagnostic cables and adapters we manufacture at our Shenzhen factory. Use these pages to match a cable to your scan tool or to send us an exact wiring specification.
Drivers, firmware and troubleshooting notes for ELM327-based USB and Bluetooth diagnostic adapters.
Open resource OBD-II Cable Pin Assignment & CodesFull OBD2 connector pinout tables plus the special-interface cable codes we build to order.
Open resource VAG KKL 409VAG KKL 409.1 interface wiring and adapter notes for VW, Audi and Seat diagnostics.
Open resource OBDII End OpenPin assignment for the 16 pin full cable, the 8 pin pass-through flat cable and the standard OBD2 connector.
Open resourceHow to use these references
Every OBD2 cable we ship is built from a defined pin map. When you order a standard part the pinout below already applies; when you order a custom harness, the same tables are the starting point we work from. If your scan tool or vehicle needs a pin combination that is not listed, send us the target device and the signal you need on each pin and we will confirm the assembly before production.
- Match by tool first. ELM327 clones, VAG KKL interfaces and OEM scan tools use different pin populations on the same J1962 shell.
- Confirm termination. End-open cables expose bare wires for panel or PCB termination; moulded cables are terminated on both ends.
- Quote from a drawing. A pinout table plus a quantity is enough for us to price a custom run.
We manufacture OBD2, VAG KKL and ELM327 cables to custom wiring specifications at our own factory. Send us the pin assignment and target quantity.