Car RCA Video Extension with Reverse Trigger for Cameras

Backup camera installations almost always run short: the camera is at the boot latch, the monitor is in the dash, and the factory lead stops halfway. This RCA video extension carries the composite video the rest of the way — male to male so it plugs straight between the camera’s RCA tail and the monitor’s input, with the detection wire carried alongside as the reverse-trigger lead for GPS navigation units that need to know when reverse gear engages.

Nickel-plated plugs ensure precise signal transmission over the run, and the build is weatherproof for outdoor use — the honest requirement for a cable that lives under the car, through boot rubbers and along sills where water, dust and heat are the daily environment. Also suited to CCTV and general audio/video signal extension duties.

Key features

• RCA male to male video extension with detection wire
• Reverse-trigger lead for GPS navigation / head units
• Weatherproof for outdoor rear-of-vehicle routing
• Nickel-plated plugs for precise signal transmission
• Also serves CCTV and AV signal extension

Specifications

An honest note on trigger wiring: the detection wire carries the reverse-lamp signal to units that auto-switch on reverse — confirm your head unit’s trigger input polarity before final routing, and fuse the tap if your vehicle’s wiring does not already protect it.

Typical applications

• Backup camera to monitor extension in cars and vans
• Rear-view parking systems with GPS navigation units
• Reversing camera retrofits on older vehicles

Samples, packing options, payment terms and warranty conditions are set out in How to Order and Delivery Information.