OBD2 Flat Noodle Extension Cable, M to F 16-Pin Pass-Through

This flat noodle extension is built for the hard-to-reach spots: an ultra-low-profile body that slides into gaps no round cable enters — under mats, behind dash trim, along the seat rail — with one male 16-pin J1962 plug into the vehicle and one female 16-pin socket presented where your device can reach it.

The pass-through carries pins 1, 2, 4, 5, 6, 7, 10, 14, 15 and 16 — the set that covers the standard passenger-vehicle OBD2 protocols — so all standard passenger car diagnostics work through the lead. It supports every standard passenger vehicle OBD2 protocol on the far end, and brand-new build quality holds up to daily coil-and-uncoil service.

There is a reason this lead has a following in the tracking trade: it is ideal for use with GPS trackers in the most discreet installations — the thin body hides where a round lead would announce itself, and the low profile keeps the install invisible.

Key features

• OBD2 male 16-pin to female 16-pin J1962 extension
• Ultra-low-profile flat noodle body for hard-to-reach spots
• Pass-through on pins 1, 2, 4, 5, 6, 7, 10, 14, 15, 16
• Supports all standard passenger vehicle OBD2 protocols
• Ideal for discreet GPS tracker installations

Specifications

An honest note on the pinout: pins not listed above are not carried through this lead — that is the point of a selective pass-through, and it suits tracker duty where the missing pins serve manufacturer-specific functions. If your device needs a full 16-pin carry, use the flat 30 cm extender in the same family instead.

Typical applications

• Discreet GPS tracker installations in fleet and private vehicles
• Scanner access in tight footwells without visible cable runs
• Extensions where a low-profile body is the requirement

Samples, packing options, payment terms and warranty conditions are set out in How to Order and Delivery Information.