OBD2 Flat Extension Cable 30 cm, Male to Female 16-Pin

The 30 cm flat extension is the shortest run in the OBD2 extender family, and its flat noodle profile is the reason it exists: 30 centimetres of cable that slips under trim panels, along footwell edges and beneath floor mats — places where a round cable bunches up, shows its bulk, or gets kicked loose. One male 16-pin plug into the vehicle socket, one female 16-pin socket at the other end for your scanner, tracker or extension chain.

The flat body also routes flatter against surfaces: less snag, less visible cable, less wear where the lead crosses a moving seat rail. It is a full pass-through — every pin carried straight across — so any 16-pin diagnostic tool behaves on the far end exactly as it would plugged into the vehicle directly, with no adapters in the chain and nothing to configure.

Key features

• OBD2 male 16-pin to female 16-pin J1962 extension
• 30 cm length, the short-reach option
• Flat noodle profile for under-trim and low-profile routing
• Full pass-through of all 16 pins
• Flexible, durable daily-service build

Specifications

An honest note on pinout: this lead is wired as a straight 1-to-1 pass-through; if your project needs specific pins carried or omitted — as some tracker installs do — confirm the pin requirement with us at sampling and we match the lead to the spec.

Typical applications

• Relocating a scanner connection within the footwell
• Clearing the driver-side port of bulky moulded plugs
• Chaining onto longer extensions to reach the bench
• Tracker installs that need a thin, short, low-visibility lead

Samples, packing options, payment terms and warranty conditions are set out in How to Order and Delivery Information.